Hook-and-loop sanding discs: size, hole pattern and backing-pad fit

A hook-and-loop sanding disc must match the sander's backing pad. Diameter is one check; attachment, extraction-hole layout and any interface pad also affect the assembly.

Check those details before choosing a pack of abrasive discs. Otherwise, a disc of the right nominal size can still leave the extraction openings obstructed or require a different backing arrangement.

Start with the pad already on the machine

Record the sander model, pad diameter and attachment type. If a pad saver or softer interface is fitted, identify that component too. It sits within the assembly and needs the correct attachment and hole pattern.

Mirka's accessory catalogue includes guidance on matching pad-saver holes to the backing pad. The useful principle is to check the whole extraction route, rather than counting holes on the abrasive in isolation.

Fit check What to compare
Diameter Abrasive, backing pad and any interface dimensions
Attachment The disc's hook-and-loop backing and the approved pad surface
Hole layout Position and alignment with the extraction openings
Interface or pad saver Its fit, hole pattern and approval for the setup
Machine requirements Approved abrasive type and operating limits

An eight-hole disc is not automatically a match for every eight-hole pad. The positions and dimensions still need to align. Photographing the existing pad next to a ruler can help identify the pattern, but use the machine or pad specification for confirmation.

Choose grit after confirming fit

The starting surface and the next process determine the abrasive selection. Lower grit numbers describe a coarser abrasive within the same system; higher numbers describe a finer one. A finer disc does not remove the need to address defects left by earlier work.

For coating preparation, use the surface-profile requirement from the coating or workpiece specification. Do not keep moving to finer grits simply because they are available. A finishing stage should have a defined purpose.

Compare hook-and-loop sanding discs by the exact product line, diameter, hole pattern and grit. Confirm which combinations can currently be supplied; a grit listed for one size may not be offered for another.

Disc construction and machine type are separate decisions

Hook-and-loop describes attachment. It does not establish a material approval or make the disc suitable for every sanding machine. Yuri's disc-construction comparison is useful when choosing between fibre, flap and sanding discs.

If you are also buying a machine, confirm the pad and extraction arrangement of the chosen sander before ordering consumables. The sanding-machine range includes different machine families; collection membership does not make their abrasives interchangeable.

A short consumables order sheet

Record the sander model, backing-pad identification, disc diameter, hole layout, grit and quantity. Add details of any interface or pad saver. State the workpiece and the next finishing process so the abrasive recommendation can be checked as well as its physical fit.

Does the disc diameter guarantee compatibility?

No. Attachment, extraction layout, the rest of the pad assembly and machine approval must also agree.

Is the finest available disc always the final stage?

No. The required surface condition determines the final stage. A coating specification, for example, may require a particular preparation rather than the finest abrasive in the range.

Back to blog